INSTALLATION PAIR VALVE ELIMINATOR KIT SUZUKI M1800R C1800R

Products covered: PLE-303

Parts:

2 x Pair valve eliminator

2 x Airbox Block Off plate

2 x Valve covers Block Off Plates

4 x Stainless steel bolts

4 x Stainless steel washers

The idea of the whole procedure is to bypass the electronic PAIR valve of the motorcycle by replacing it with the provided PAIR valve eliminator. To remove the PAIR valve solenoid from the airbox and cover it with the provided block off plate and install the provided block off plates to the engine valve covers.

This kit will let you completely remove the PAIR system from your motorcycle.

Please read the steps carefully before starting the installation and note that the ignition must be turned OFF during the whole procedure

STEP 1: Lift and support the fuel tank. Locate the PAIR valve at the front bottom left of the airbox and the PAIR system hoses connected on the cylinder heads .

STEP 2: Unplug the PAIR hoses from the PAIR plates on the cylinder heads.

STEP 3: Disconnect the PAIR valve connectors from the wiring harness and connect the provided PAIR valve eliminators in their place.

STEP 4: Release the PAIR valve wire, remove the 2 screws that hold the PAIR valves on the airbox and now they atr free to be detached. Keep the o-rings that seal the holes on the airbox and install the airbox block off plates using the PAIR valve bolts

STEP 5: Locate the two PAIR valve plates on the cylinder heads

STEP 6: Unscrew the two bolts of each plate, remove the external plastic PAIR plate but leave the internal plate in place.

STEP 7: Put each block off plate against the engine valve cover and align the block off plate holes with the engine valve cover holes.

Also align the spots that are shown in the pictures of the internal plate and the block off plate.

Use the provided stainless steel bolts and washers to install the plates and tighten each bolt to 10nm of torque.

You have bypassed the PAIR system!

That’s it, now you can put everything in place and start the engine.

Thank you very much.

If you have any suggestions for improvement or if you wish to help, feel free to contact us through the contact form.